top of page

See also ...

LIFTING EYE NUTS "MWLEN582" WHITWORTH THREADS

WW - Whitworth

Whitworth threading is measured in inches (1"=25,4mm), and is characterised by a 55° angle for each crest and each groove of the threading.  It was created in England and used as an international standard until its progressive replacement with the ISO Metric system.

100% MADE IN ITALY

2018 - 2AA Lifting Eye Nuts DIN 582 2018

WW

The following sizes are made from lifting eye bolt bodies (pay attention to the dimensions in red)

2018 - 2AB Lifting Eye Nuts DIN 582 2018
2018 - AVVERTENZE WLL EN 2018.jpg

 

MATERIAL

 

In accordance with standards DIN 580:2018 and DIN 582:2018, the carbon steel used for the construction of lifting eye bolts and lifting eye nuts is aluminium killed steel C15E (EN 10084/98).

A2 (AISI 304) or A4 (AISI 304)  stainless steel is also used for the construction of lifting eye bolts and lifting eye nuts.  Other materials can be employed for special applications. 

 

SURFACE FINISHES

 

Non-machined lifting eye bolts and lifting eye nuts are usually supplied as semi-finished forged pieces (sand-blasted).

White zinc-plated lifting eye bolts and lifting eye nuts (minimum 8 microns) and hot-dip galvanised lifting eye bolts and lifting eye nuts (minimum 78 microns) are also ready for immediate delivery. 
Other surface treatments are available on request (yellow zinc-plating, dacromet, Delta Protekt, Delta Tone, Delta Seal, painting etc.).

 

These eye nuts with special threading are not included in standard DIN 582:2018 and cannot therefore be marketed as DIN 582:2018.

For this reason we have created a table named MWLEN582 (Mec Wolf Lifting Eye Nuts) by adopting the sizes of standard DIN 582 and DIN 580 unfinished bodies after machining with special threading.

 

For these products we guarantee the same mandatory requirements provided for by standard DIN 582:2018 and by the Machinery Directive 2006/42/CE; these products must therefore be considered to be perfectly compatible with standard DIN 582/580 and compliant with the Machinery Directive EN/2006/42.

 

Click here to view the mandatory requirements for the marketing and use of eye bolts and eye nuts.

bottom of page